JBA sparks innovation for COVID-19 facemasks

3D printers rest on a table at the SparkX Cell Innovation and Idea Center on Joint Base Andrews, Md., Apr. 8, 2020. Each printer can print up to four facemasks at a time, depending on the model created. Printers can print one facemask in as little as three hours with one hour of post-processing. (U.S. Air Force photo by Airman 1st Class Spencer Slocum)

PHOTO BY: Airman 1st Class Spencer Slocum
VIRIN: 200408-F-AP370-1031.JPG
FULL SIZE: 0.49 MB
Additional Details

CAMERA

NIKON D850

LENS

24.0-70.0 mm f/2.8

APERTURE

35/10

SHUTTERSPEED

1/160

ISO

2000

IMAGE IS PUBLIC DOMAIN

Read More

This photograph is considered public domain and has been cleared for release. If you would like to republish please give the photographer appropriate credit. Further, any commercial or non-commercial use of this photograph or any other DoD image must be made in compliance with guidance found at https://www.dimoc.mil/resources/limitations, which pertains to intellectual property restrictions (e.g., copyright and trademark, including the use of official emblems, insignia, names and slogans), warnings regarding use of images of identifiable personnel, appearance of endorsement, and related matters.

Go to Gallery